LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2017 >> RS 3 >> Repair and Diagnosis >> External Pages >> Different car >> Section 229 (Turbocharger, Supercharger 2.0L (CNSB, CNTC, CYFB, DJJA)) >> 21 Turbocharger, Supercharger >> Charge Air System >> Charge Air Pressure Sensor -G31-, REMOVING AND INSTALLING >> Removing

Charge Air Pressure Sensor -G31-, REMOVING AND INSTALLING: Removing

WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2018 Audi S3, 2018 Audi A3 Quattro, 2017 Audi S3, 2017 Audi A3 Quattro, and 2016 Audi S3. However, it is still accessible from the selected car via links, so may be relevant.

-- Remove the noise insulation. Refer to NOISE INSULATION, REMOVING AND INSTALLING .

-- Disconnect the connector -2-.

Fig 1: Component Location Charge Air Pressure Sensor -G31-
GWWA21-10817Courtesy of AUDI OF AMERICA, LLC

-- Remove the bolts -1- and remove the Charge Air Pressure Sensor -G31- from the air duct pipe.

scientia non olet · About LEMON Manuals