Perform Adaptations After Component Replacement
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2017 Audi S3, 2017 Audi A3 Quattro, 2017 Audi A3, 2016 Audi S3, and 2016 Audi A3 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
The adaptation values must be adapted when components of the engine or reducing agent system are being replaced, or when a reducing agent line was opened:
After replacing the component, the necessary program must be executed using the Vehicle Diagnostic Tester.
-- Connect the Vehicle Diagnostic Tester.
-- Select Diagnostic operating mode and Start diagnostics .
-- Select the Select individual test tab and select the following tree structure consecutively:
- Drivetrain
- Select the engine code and engine
- 01 - OBD-capable systems .
- 01 - Engine Control Module -J623-
- 01 - Engine electronics, functions
- 01 - Steps after replacing component