Reducing Agent Injector -N474-, Removing And Installing: Installing
WARNING: This page is about a different car, the 2016 Audi A3 and 2015 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.
Install In Reverse Order Of Removal.Note The Following:
Replace the seal.
- Installed position: The tabs in the Reducing Agent Injector -N474- -2- must fit into the mounts in the exhaust pipe -1- -arrows-.
- Secure all hose connections with hose clamps that match the ones used in series production. Refer to the Parts information.
-- Install the engine cover. Refer to ENGINE COVER, REMOVING AND INSTALLING .
Adapt the adaptation value for the SCR system after draining reducing agent or replacing components. Use the Vehicle Diagnostic Tester.
- Select 01 - On Board Diagnostic (OBD) Capable Systems
- 01 - Engine Electronics
- 01 - Engine Electronics, Functions
- 01- Adaptation Value - Reducing Agent System, Reseting