Exhaust Gas Temperature Sensor 1 -G235-, REMOVING AND INSTALLING: Installing
WARNING: This page is about a different car, the 2016 Audi A3 and 2015 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.
Install In Reverse Order Of Removal. Note The Following:
- Protect the exhaust gas temperature sensor against knocks and impacts. A dropped exhaust gas temperature sensor may not be used again.
-- Coat the thread with hot bolt paste. Refer to the Parts information.
Installed location of the Exhaust Gas Temperature Sensor 1 -G235- :
- The angled shaft -1- must point downward vertically.
-- During installation, all cable ties must be installed at the same location.
-- Install the engine cover. Refer to ENGINE COVER, REMOVING AND INSTALLING .