Tightening Sequence Continuation

WARNING: This page is about a different car, the 2016 Audi A3 and 2015 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.

Courtesy of AUDI OF AMERICA, LLC

Step	Bolt	Steps
8.	Bolt -5-	Install and pull to engage.
9.	Bolt -5-	Tighten to 20 Nm
10.	Bolt -5-	additional 90° turn.
11.	Bolt -5-	An additional 45° turn

-- Remove the :T10511 .

-- Install the Exhaust Gas Temperature Sensor 4 -G648-. Refer to EXHAUST GAS TEMPERATURE SENSOR 3 -G495- /EXHAUST GAS TEMPERATURE SENSOR 4 -G648-, REMOVING AND INSTALLING .

The rest of the assembly is performed in reverse order of removal, noting the following:

AWD Vehicles:

-- Fasten the driveshaft on the bevel box. Refer to the appropriate service information. .

-- Install the right drive axle on the bevel box. Refer to OVERVIEW - DRIVE AXLE (VARIETY) / OVERVIEW - DRIVE AXLE / DRIVE AXLE, REMOVING AND INSTALLING .

Vehicles With Parking Heater:

Courtesy of AUDI OF AMERICA, LLC

-- Install the coolant pipes.

Continuation For All Vehicles:

-- Install the EGR cooler. Refer to EGR COOLER, REMOVING AND INSTALLING .

-- Install the NOx Sensor -G295-. Refer to NOx SENSOR -G295-, REMOVING AND INSTALLING .

-- Install the Exhaust Gas Temperature Sensor 3 -G495-. Refer to EXHAUST GAS TEMPERATURE SENSOR 3 -G495- /EXHAUST GAS TEMPERATURE SENSOR 4 -G648-, REMOVING AND INSTALLING .

-- Install the Heated Oxygen Sensor -G39-. Refer to HEATED OXYGEN SENSOR -G39-, REMOVING AND INSTALLING .