Differential Pressure Sensor -G505-, Removing And Installing: Installing
WARNING: This page is about a different car, the 2016 Audi A3 and 2015 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.
Install In Reverse Order Of Removal.Note The Following:
-- Before installing, clean the control lines leading from the Differential Pressure Sensor -G505- to the particulate filter with compressed air to make sure they are not plugged or iced over with condensation water.
-- When connecting the hoses check the hoses for secure fit and leaks.
- Secure all hose connections with hose clamps that match the ones used in series production. Refer to the Parts information.
-- Install the engine cover. Refer to ENGINE COVER, REMOVING AND INSTALLING .
-- After replacing the Differential Pressure Sensor -G505-, the adaptation values must be adapted in the engine control module.
-- Turn on the ignition and select the following menu items using the Vehicle Diagnostic Tester.
- Select 01 - On Board Diagnostic (OBD) Capable Systems
- 01 - Engine Electronics
- 01 - Engine Electronics, Functions
- 01 - Reseting Adaptation Values