Cooling System Charge Kit - Electric Vacuum Pump :Vas6096/2, Checking
WARNING: This page is about a different car, the 2016 Audi A3 and 2015 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.
TIP:
- Before using the :VAS6096 and the :VAS6096/2 , a check must be performed to ensure that the cooling system is filled correctly.
-- Connect the hose -1- of the :VAS6096/2 to the connector coupling -B- on the :VAS6096 .
-- Connect the :VAS6096/2 on the vehicle battery and switch on.
-- Close valve -A- and open valve -B-.
-- The needle on the pressure gauge -arrow- must move until it is well below the green area.
-- Close the valve -B- and switch off the :VAS6096/2 .
-- Monitor the vacuum on the pressure gauge for 10 seconds. The needle must not move.
If not enough vacuum builds up, or the pressure continues to increase:
The :VAS6096 , the pressure gauge or the :VAS6096/2 is leaking or faulty and must not be used.