LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2017 >> RS 3 >> Repair and Diagnosis >> External Pages >> Different car >> Section 12 (COOLING SYSTEM (4-Cylinder TDI Common Rail 1.6L; 2.0L 4V Engine) -- (A3 SEDAN)) >> 19 Cooling System >> Coolant Pipes >> Coolant Pipes, Removing And Installing >> Upper Coolant Pipes, Removing And Installing >> Installing

Upper Coolant Pipes, Removing And Installing: Installing

WARNING: This page is about a different car, the 2016 Audi A3 and 2015 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.

Install In Reverse Order Of Removal. Note The Following: 

-- Connect the coolant hose to the connector coupling. Refer to CONNECT THE COOLANT HOSE TO THE COUPLING .

CAUTION:

- Fill the coolant system using only the Vehicle Diagnostic Tester.

-- Fill and bleed the coolant circuit. Refer to COOLANT, DRAINING AND FILLING WITHOUT COOLING SYSTEM CHARGE KIT - ELECTRIC VACUUM PUMP:VAS6096/2 .

-- Install the engine cover. Refer to ENGINE COVER, REMOVING AND INSTALLING .

scientia non olet · About LEMON Manuals