Oil Pump, Removing And Installing: Installing
Install in reverse order of removal and note the following:
- Replace the oil baffle after removal.
- Replace the bolts that were tightened with an additional turn.
-- Make sure both alignment bushings for centering the oil pump are installed.
-- Before installing check the screen -21- OVERVIEW - OIL PAN/OIL PUMP in the oil pump and the oil channel in the oil pan upper section for debris.
-- Guide the oil pump chain sprocket into the drive chain and install the oil pump.
- Make sure that the tension spring of the chain tensioner is in the installation position.
-- Pull the wire clip of the chain tensioner tension spring with the :T10118 in direction of -arrow- and remove the :T40265 .
-- Check the support of the wire clip for the chain tensioner tension spring.
- The wire clip -2- must be supported as shown on the locating tab -1- of the oil pan upper section -arrow-. (Shown when removing the lower timing chain cover.)
-- Insert the oil baffle -8- OVERVIEW - OIL PAN/OIL PUMP and secure it.
-- Install the oil pan lower section. Refer to OIL PAN LOWER SECTION, REMOVING AND INSTALLING .