Vibration Damper, Removing And Installing: Removing

Depending on the model, preliminary work may be required. Refer to * .

-- If equipped remove the noise insulation. Refer to Noise Insulation, Removing And Installing .

-- Remove the ribbed belt, but do not lock the tensioner. Refer to RIBBED BELT, REMOVING AND INSTALLING ).

Courtesy of AUDI OF AMERICA, LLC

-- Turn the crankshaft using the :T40263  , :T40314  and the 24 mm socket in the direction of engine rotation -arrow- until the vibration damper is at "TDC".

• The notch -1- on the vibration damper must align with the arrow marking -2- on the lower timing chain cover.
• The marking on the cover is located in the >>four-o'clock position<<.
• The vibration damper bolts can only be loosened maximum ¹ /₂ turn at first.

-- Loosen the vibration damper bolt approximately ¹ /₂ , to do this use the :T10355  .

Courtesy of AUDI OF AMERICA, LLC

-- If the vibration damper was turned, correct to "TDC".

-- Remove the bolts -arrows- for the lower timing chain cover.

Courtesy of AUDI OF AMERICA, LLC

-- Place the :T10531/1  as shown on the vibration damper and tighten the knurled bolt -arrows- hand-tight.

Courtesy of AUDI OF AMERICA, LLC

• The arrow marking on the :T10531/1  must point upward.

-- Remove the vibration damper bolt completely.

-- Check if the :T10531/3  -item A- can be easily pushed over the clamping piece -B-. If necessary turn the tensioning bolt -arrow-.

Courtesy of AUDI OF AMERICA, LLC

• Do not turn the tensioning bolt further, otherwise the :T10531/2  becomes jammed when installing in the crankshaft

-- Install the :T10531/2  in the crankshaft and tighten it hand-tight using a 12 mm open end wrench -item A-.

Courtesy of AUDI OF AMERICA, LLC

-- Tighten the adjusting bolt -A- hand-tight, to secure the chain sprocket to the crankshaft.

Courtesy of AUDI OF AMERICA, LLC

-- Remove the knurled bolts -arrows-. Remove the :T10531/1  and vibration damper -A-.

Courtesy of AUDI OF AMERICA, LLC

If the Crankshaft Should Be Turned without the Vibration Damper: 

Courtesy of AUDI OF AMERICA, LLC

-- Place the :T10531/3  -item A- on the :T10531/2  and pay attention to the chain sprocket tooth contour while doing so.

• The flat side of the tool is at the top in TDC.

-- Tighten the turning over tool using the :T10531/4  -item B-.

-- The crankshaft can now be turned at the hex fitting -arrow-.

Courtesy of AUDI OF AMERICA, LLC