Overview - Cylinder Block, Belt Pulley Side

Fig 1: Cylinder Block, Belt Pulley Side

Courtesy of AUDI OF AMERICA, LLC

1. Ribbed Belt
   • Check for wear
   • Do not kink
   • Ribbed belt routing. Refer to Fig 2.
   • Before removing, mark the running direction using chalk or a felt-tip pen.
   • When installing, make sure it is seated correctly on the belt pulleys
   • Removing and installing. Refer to RIBBED BELT, REMOVING AND INSTALLING .
2. Ribbed Belt Tensioner
   • To release tension on ribbed belt, pivot using a wrench.
   • Secure using the Locking Pin :T10060 A 
   • Removing and installing. Refer to RIBBED BELT TENSIONER, REMOVING AND INSTALLING .
3. Bolt
   • 8 Nm + 45°
   • Always replace after removing
4. Bolt
   • 150 Nm + 90°
   • Always replace after removing
   • Use the Counterhold - Vibration Damper :T10355  to loosen and tighten
   • Coat the O-ring with engine oil
5. O-ring
   • Not a replacement part; supplied with the bolt
6. Vibration Damper
   • With the ribbed belt pulley
   • Removing and installing. Refer to VIBRATION DAMPER, REMOVING AND INSTALLING .
7. Sub-Assembly Bracket
   • With oil filter housing and engine oil cooler
   • Removing and installing the sub-assembly bracket. Refer to SUB-ASSEMBLY BRACKET, REMOVING AND INSTALLING .
   • Removing and installing the engine oil cooler. Refer to ENGINE OIL COOLER, REMOVING AND INSTALLING .
8. Seal
   • Always replace after removing
9. Bolt
   • Tightening Specifications and Sequence. Refer to  4.
   • Always replace after removing
10. Bolt
    • Tightening specifications. Refer to OVERVIEW - GENERATOR .
11. Generator
    • Removing and installing. Refer to GENERATOR, REMOVING AND INSTALLING .
12. Alignment Sleeves
    • For the A/C compressor
13. A/C Compressor
    • Do not remove or disconnect the refrigerant lines
    • Removing and installing. Refer to A/C Compressor, Removing And Installing .
14. Bolt
    • Tightening specification. Refer to Overview - A/C Compressor Power Unit .

Fig 2: Damper, Tensioner, Generator And A/C Compressor

Courtesy of AUDI OF AMERICA, LLC

1. Vibration Damper
2. Ribbed Belt Tensioner
3. Generator
4. A/C Compressor

Courtesy of AUDI OF AMERICA, LLC

-- Mount the sub-assembly bracket and then install the bolts -4- first.

• Replace the bolts that were tightened with an additional turn after removing them.

-- Tighten the bolts in the steps shown in the sequence: