Ribbed Belt TENSIONER, Removing And Installing, Version 1: Installing
Install in reverse order of removal and note the following:
-- Insert the ribbed belt tensioner -2- into the sub-assembly bracket -4- and tighten the bolt -6-.
- Note the installation position of the support -3- : Insert the tabs on the support into the hole in the sub-assembly bracket.
- Note the centering bracket -5-.
-- Install the ribbed belt. Refer to RIBBED BELT, REMOVING AND INSTALLING .
There are additional procedures depending on the model. Refer to RIBBED BELT TENSIONER, REMOVING AND INSTALLING .