All Wheel Drive Clutch Pump -V181-, REMOVING AND INSTALLING, GENERATION V: Removing

-- Turn off the ignition.

-- Place the : SMN372500  under rear the final drive.

-- Remove the drain plug -1- and completely drain the High Performance All Wheel Drive Clutch Oil.

-- Install the new drain plug -1- with a new seal.

-- Remove the connector -arrow- for the All Wheel Drive Clutch Pump -V181- from the All Wheel Drive Control Module -J492-.

-- Remove and free up the wiring harness -3- for the All Wheel Drive Clutch Pump -V181- from the housing.

-- Loosen the bolt -arrow- on the front final drive mounting bracket approximately seven turns.

-- Place the : SMN372500  under rear the final drive.

-- Remove the bolt -1- from the All Wheel Drive Clutch Pump -V181-.

-- Remove the All Wheel Drive Clutch Pump -V181- -2- from the all wheel drive Clutch housing.