Seat Pan Cover And Padding, Removing And Installing, Standard/Folding Seat: Removing
- Follow all safety precautions when working with pyrotechnic components. Refer to PYROTECHNIC COMPONENTS SAFETY PRECAUTIONS .
- Before handling pyrotechnic components (for example, disconnecting the connector), the person handling it must "discharge static electricity". This can be done by touching the door striker, for example.
-- Remove the front seat. Refer to FRONT SEAT, REMOVING AND INSTALLING .
-- Fasten the front seat on the Engine/Transmission Holder - Seat Repair Fixture :VAS6136 . Refer to FRONT SEAT, MOUNTING ON FIXTURE FOR SEAT REPAIR .
-- Remove the backrest. Refer to FRONT BACKREST, REMOVING AND INSTALLING .
-- Versions with passenger seat child seat anchor: remove the child seat anchor. Refer to FRONT CHILD SEAT ANCHOR, REMOVING AND INSTALLING .
-- Vehicles with drawer: remove the drawer. Refer to DRAWER MOUNT, REMOVING AND INSTALLING .
-- Equipment level with storage compartment: remove the storage compartment. Refer to STORAGE COMPARTMENT, REMOVING AND INSTALLING .
-- Remove the sill panel side seat side trim with the bracket.
- Front seat manual. Refer to SEAT SIDE TRIM ON SILL PANEL SIDE, REMOVING AND INSTALLING, MANUAL FRONT SEAT .
- Folding seat. Refer to SEAT SIDE TRIM ON SILL PANEL SIDE, REMOVING AND INSTALLING, PASSENGER FOLDING SEAT .
- Front seat power. Refer to SEAT SIDE TRIM ON SILL PANEL SIDE, REMOVING AND INSTALLING, POWER FRONT SEAT .
-- Disconnect and free up the connectors.
-- Detach the molding -1- from the seat cover in the front and side areas using the Backrest Panel Tool:3370 -arrow-.
-- Detach molding -2- of the seat cover in the rear area using the Backrest Panel Tool:3370 .
-- Remove the seat cover with the seat cushion from the seat pan. If necessary, free up the wiring harness for the seat heating and passenger occupant detection system.