All Wheel Drive Clutch Pump -V181-, REMOVING AND INSTALLING, GENERATION IV: Removing

-- Turn off the ignition.

-- Place the : VAS6208  underneath.

-- Remove the drain plug -1- and completely drain the High Performance All Wheel Drive Clutch Oil.

-- Install the drain plug -1- with a new seal. Refer to COMPONENT LOCATION OVERVIEW - DRAIN AND CHECK PLUGS .

-- Lower the final drive slightly. The fastening bolt -arrow- on the front final drive mounting bracket must be unscrewed approximately seven turns for this purpose.

-- Remove the pump connector -arrow- from the control module.

-- Remove the wiring harness together with the bracket -A- from the housing and set aside.

-- Press the retaining tabs -B- together as far as possible and slide into the housing hole.

-- Hand tighten the fastening bolt -arrow- again.

-- Place : VAS6208  under final drive.

-- Remove the fastening bolts of the pump -1-.

-- Pull pump -arrow- out of all wheel drive clutch housing together with cable protection -2-.