Turbocharger, Removing And Installing: Installing

WARNING: This page is about a different car, the 2016 Audi Q3 Quattro, 2016 Audi Q3, 2015 Audi Q3 Quattro, and 2015 Audi Q3. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal. Note the following:

NOTE:

Replace the seals, O-rings and the self-locking nuts.

Fill the turbocharger with engine oil at the connection for oil supply line.

Secure all hose connections with hose clamps of the same type as those equipped by the factory. Refer to the parts information.

After installing turbocharger, let engine idle for approximately 1 minute without increasing engine speed. This ensures adequate oil supply to the turbocharger.

-- Electrical connections and wiring routing. Refer to appropriate SYSTEM WIRING DIAGRAMS.

-- Install the Heated Oxygen Sensor -G39-. Refer to Heated Oxygen Sensor -G39-, REMOVING AND INSTALLING .

-- Install the air guides. Refer to OVERVIEW - CHARGE AIR HOSE CONNECTIONS .

-- Install the front exhaust pipe with the catalytic converter. Refer to FRONT EXHAUST PIPE, REMOVING AND INSTALLING .

-- Install the right wheel spoiler. Refer to Front Wheel Spoiler, Removing And Installing .

NOTE:

Do not reuse used coolant.

-- Fill with coolant. Refer to COOLANT, DRAINING AND FILLING .

-- Install the noise insulation. Refer to Noise Insulation, Removing And Installing .