Overview - Balance Shaft Drive Chain: Notes
WARNING: This page is about a different car, the 2016 Audi Q3 Quattro, 2016 Audi Q3, 2015 Audi Q3 Quattro, and 2015 Audi Q3. However, it is still accessible from the selected car via links, so may be relevant.
- Guide Pins
- 20 Nm
- Glide Rail
- For the timing chain
- Timing Chain
- Removing. Refer to BALANCE SHAFT DRIVE CHAIN, REMOVING AND INSTALLING .
- Guide Pins
- 20 Nm
- Tensioning Rail
- For balance shaft drive chain
- Balance Shaft
- Exhaust side
- Must be replaced after removing
- Lubricate the bearing with engine oil
- Replacing. Refer to .
- Guide Pins
- 20 Nm
- Glide Rail
- For the timing chain
- Chain Tensioner
- 85 Nm
- Coat the seal with sealant
- Three Stage Chain Sprocket
- Installed position. Refer to 15
- O-Ring
- Lubricate with engine oil
- Mounting Pin
- Lubricate with engine oil
- Installed position. Refer to 15
- Intermediate Sprocket
- The intermediate sprocket must be replaced if the bolt -item 15- OVERVIEW - BALANCE SHAFT DRIVE CHAIN is loosened.
- Washer
- Bolt
- Always replace
- The intermediate sprocket -item 13- OVERVIEW - BALANCE SHAFT DRIVE CHAIN must be replaced if the bolt is loosened.
- Tightening sequence. Refer to the illustration below
- Replace and lubricate the O-ring -1-
- The alignment pin -arrow- for the bearing pins must engage in the hole in the cylinder block.
- Lubricate the bearing pins