Valve Stem Seals, Removing And Installing, Cylinder Head Installed: Procedure

-- Remove the camshafts. Refer to CAMSHAFT, REMOVING AND INSTALLING .

-- Remove the spark plugs using the : 3122B .

Courtesy of AUDI OF AMERICA, LLC

Guide Plate, Reworking:

Courtesy of AUDI OF AMERICA, LLC

-- Check if the opening -arrow- is present.

-- If necessary, rework the : VAS5161A -arrow- until the guide plate touches the cylinder head and the guide pin -1- is free.

Continuation:

Courtesy of AUDI OF AMERICA, LLC

-- Tighten the : VAS5161/19C on the cylinder head as shown using the : VAS5161/12 .

-- Set the piston for the respective cylinder to "bottom dead center (BDC)".

-- Install the : T40012 in the spark plug threads.

Courtesy of AUDI OF AMERICA, LLC

-- Connect compressed air with at least 6 bar (87.02 psi).

-- Loosen stuck valve retainers using a : VAS5161/3A and a plastic hammer.

Intake Side:

Courtesy of AUDI OF AMERICA, LLC

-- Install the : VAS5161/6 with the : VAS5161/5 in the center threads of the : VAS5161/19C .

Exhaust Side:

Courtesy of AUDI OF AMERICA, LLC

-- Install the : VAS5161/6 with the : VAS5161/5 in the outer threads of the : VAS5161/19C .

Continuation:

-- Insert the : VAS5161/8A into the : VAS5161/19C .

-- Engage the : VAS5161/2 on the : VAS5161/6 .

-- Press down the : VAS5161/8A and at the same time turn the knurled thumb screw on the : VAS5161/8A to the right until the points engage in the valve retainers.

-- Move the knurled thumb screw back and forth slightly. This presses the valve retainers apart and captures them in the installation cartridge.

-- Release the : VAS5161/2 .

-- Remove the : VAS5161/8A .

-- Remove the valve stem seals using : 3364 .

Courtesy of AUDI OF AMERICA, LLC

In order not to damage the valve stem seal -4- during installation, mount the Mounting Sleeve -3- on the valve stem -2-.

Courtesy of AUDI OF AMERICA, LLC

-- Lightly oil the valve stem seal sealing lip.

-- Insert the valve stem seal in the : 3365 -5- and carefully press on over the Mounting Sleeve on the valve guide -1- all the way.

-- Remove the Mounting Sleeve.

-- Insert the valve spring and valve spring retainer.

-- Connect the : VAS5161A as shown.

Intake Side:

Courtesy of AUDI OF AMERICA, LLC

Continuation:

Courtesy of AUDI OF AMERICA, LLC

If the valve retainers were removed from the assembly cartridge, they must then be inserted into the : VAS5161/18 .
Press the Valve Cotter Tool Kit - Assembly Cartridge : VAS 5161/8A onto the insertion tool from above.

-- Press the : VAS5161/8A down with the : VAS5161/2 and rotate the cartridge knurled thumb screw back and forth while pulling up.

-- Release the : VAS5161/2 with the knurled thumb screw pulled.

-- Remove the : VAS5161A .

-- Repeat the procedure on each valve.