Overview - Cylinder Head

Fig 1: Exploded View Of Cylinder Head Components

Courtesy of AUDI OF AMERICA, LLC

1. Alignment Pin
   • Quantity: 2
2. Cylinder Head Gasket
   • Always replace after removing
   • Installed position: the part number faces the cylinder head
   • Change the coolant and engine oil after replacing
3. Cylinder Head
   • Checking for distortion. Refer to Fig 4.
   • Change the coolant and engine oil after replacing
   • Removing and installing. Refer to CYLINDER HEAD, REMOVING AND INSTALLING .
4. Bolt
   • Tightening specification and sequence. Refer to Fig 3.
   • Always replace after removing
   • Loosening. Refer to Fig 2.
5. Heat Shield
   • Equipped on some models
6. Bolt
   • 9 Nm
7. Bolt
   • 9 Nm
8. Heat Shield
   • There are different versions. Refer to the parts information for the allocation.
9. Bolt
   • 9 Nm
10. Bolt
    • 9 Nm
11. Connection
    • For coolant hose
12. O-ring
    • Always replace after removing
    • Coat with coolant
13. Bolt
    • Tightening Specifications and Sequence. Refer to Fig 3.
    • Always replace after removing
    • Loosening. Refer to Fig 2.
14. O-ring
    • Always replace after removing
    • Coat with coolant
15. Connection
    • For coolant hose
16. Bolt
    • 9 Nm
17. Mount
    • For the engine cover
18. Engine Lifting Eye
19. Bolt
    • 10 Nm + 90°
    • Always replace after removing
20. Partition Plate
21. Ball Pin
    • For the engine cover
22. Engine Lifting Eye
23. Bolt
    • 10 Nm + 90°
    • Always replace after removing
24. Alignment Pin

Fig 2: Loosening Cylinder Head Bolts In Sequence

Courtesy of AUDI OF AMERICA, LLC

-- Remove the bolts -arrows-.

-- Loosen and remove the cylinder head bolts in the sequence -1 to 10-.

Fig 3: Cylinder Head Bolts Tightening Sequence

Courtesy of AUDI OF AMERICA, LLC

• Replace the bolts that were tightened with an additional turn after removing them.

-- Tighten the bolts in the steps shown in the sequence:

Cylinder Head Bolts Tightening Sequence 

Fig 4: Checking Cylinder Head At Several Locations For Distortion

Courtesy of AUDI OF AMERICA, LLC

-- Check the cylinder head at several locations for distortion using a Straight Edge - 500mm: VAS6075  and a feeler gauge.

• Maximum permitted distortion: 0.05 mm