Vibration Damper Seal, Replacing
Special tools and workshop equipment required
- Seal Installer - Crankshaft :T10354
- Press Piece - Gearbox :T10375
- Vibration Damper Assembly Tool - Knurled Nut :T10531/4 from the Vibration Damper Assembly Tool:T10531
- Seal Installer - Crankshaft :T40274
Procedure
Preliminary work may be required depending on the model. Refer to TIMING CHAIN COVER, REMOVING AND INSTALLING
-- Remove the vibration damper. Refer to VIBRATION DAMPER, REMOVING AND INSTALLING .
-- Remove the seal -arrow- with the :T40274 .
-- Clean the contact and sealing surface.
-- Push the seal -arrow- on the :T10354 .
- The closed side of the seal points to the :T10354 .
-- Push the seal -arrow- with the :T10354 on the :T10531/2 and place on the lower timing chain cover.
-- Additionally attach the :T10375 and tighten the :T10531/4 .
-- Drive the seal in all the way using the :T10354 .
Further installation is performed in reverse order of removal, while noting the following:
- Replace the bolt with O-ring for the vibration damper after removal.
-- Install the vibration damper. Refer to VIBRATION DAMPER, REMOVING AND INSTALLING .