Bearing Bracket, Removing And Installing: Removing

Preliminary work may be required depending on the model. Refer to TIMING CHAIN COVER, REMOVING AND INSTALLING .

-- Remove the upper timing chain cover. Refer to UPPER TIMING CHAIN COVER, REMOVING AND INSTALLING .

TIP: 

The control valves have left-hand thread.

-- Depending on the version, remove the control valve in the direction of -arrow- using either the :T10352A  or :T10352/1A  .

-- To do so counterhold on the vibration damper with the :T40263  , :T40314  and the 24 mm socket.

-- Remove the bolts -arrows-.

• Carefully remove the bearing mount, without tilting.

-- Remove the bearing mount.

-- Open the clamps -1 and 2- and remove the air duct hoses.

-- Remove the bolts -arrows- and remove the air duct pipe.

-- Remove the plug -arrow-.

-- Remove the bolts -arrows-.

-- Remove the bolt -arrow-.

Two Different Chain Tensioners May Be Installed Depending on the Version: 

Version 1: 

-- Install the :T40243  -arrows-.

-- Lift up the locking wedge for the chain tensioner by inserting a scriber or a suitable screwdriver into the chain tensioner opening in direction of -arrow 1-. Slowly press and hold the :T40243  in direction of -arrow 2-.

-- Secure the chain tensioner using the :T40011  .

Version 2: 

-- Install the :T40243  -arrows-.

-- Press the chain tensioner circlip -1- together and slowly press and hold the :T40243  in the direction of -arrow-.

-- Secure the chain tensioner with the :T40267  .

All Versions: 

-- Remove the :T40243  .