Component Location Overview - Seals

1. Nut
   • Tightening Specification OVERVIEW - ALL WHEEL DRIVE CLUTCH .
   • Secure using the Locking Compound: D 000 600  .
2. Driveshaft Flange
   • Removing and Installing. Refer to DRIVESHAFT FLANGE SEAL, REPLACING .
3. Flange/Driveshaft Seal

   Replacing. Refer to DRIVESHAFT FLANGE SEAL, REPLACING .

4. Right Seal
   • Replacing. Refer to RIGHT SEAL, REPLACING .
   • For the right flange shaft
5. Circlip
   • Replace after removing the flange shaft. Refer to Fig 1.
6. Right Flange Shaft
   • Removing and Installing. Refer to RIGHT SEAL, REPLACING .
7. Rear Final Drive
8. Left Seal
   • Replacing. Refer to LEFT SEAL, REPLACING .
   • For the left flange shaft
9. Left Flange Shaft
   • Removing and Installing. Refer to LEFT SEAL, REPLACING .

Fig 1: Clamping Flange Shaft In Vise With Jaw Protectors

Courtesy of AUDI OF AMERICA, LLC

-- Clamp the flange shaft in a vise with protective jaws.

-- Use the new circlip -A- to press the previous circlip out of the flange shaft groove.