Overview - Final Drive
- Bolt
- 60 Nm + 180°
- Always replace after removing
- Quantity: 3
- Stop Washer
- Place on the bonded rubber bushing. Refer to OVERVIEW - SUBFRAME MOUNT .
- Washer
- Installation position: the bevel (smaller diameter) faces the subframe
- Bolts
- 60 Nm + 180°
- Always replace after removing
- Rear Subframe
- Stop Washers
- Place on the bonded rubber bushing. Refer to OVERVIEW - SUBFRAME MOUNT .
- Rear Final Drive
- Removing and installing. Refer to FINAL DRIVE, REMOVING AND INSTALLING .
- Bonded rubber bushing, removing and installing. Refer to OVERVIEW - SUBFRAME MOUNT .