Adjusting via the Hinge
-- The roof spoiler is removed. Refer to ROOF EDGE SPOILER, REMOVING AND INSTALLING .
-- Remove the seal -1-.
To ensure that it is water tight, after installing the seal coat it completely with Adhesive/Sealant:D 511 500 A2 .
-- Loosen the bolts on the lid -2- from the inside at the hex fitting.
-- Close the rear lid and align it with the body contour.
-- Fasten the bolts -2- to the lid retainer with an outer torx socket E5 to the left to maximum of 7 Nm.
-- Open the rear lid and tighten the bolts on the bolts on the hex fitting. Refer to -item 2-.
-- Install the rear spoiler.