STRIKER, REMOVING AND INSTALLING, VEHICLES WITH Rear Lid Lock Unit -F256-: Installing

Install in reverse order of removal. Note the following:

NOTE:

The striker pin must only be installed in the "Closed rear lid" position.

A new striker pin will always be in the "Closed rear lid" position.

-- If the same striker pin is reinstalled, connect the connector to the Door Closing Assist Control Module, and when the rear lid is open, close the rotary latch in the rear lid latch with, for example, a screwdriver.

Closing aid operates in "Closed rear lid" position = basic position.

-- Disconnect the connector on the Door Closing Assist Control Module.

-- Open the latch again via the Rear Lid Lock Cylinder Unlock Button.

-- Adjust the catch. Refer to ADJUST USING CATCH, VEHICLES WITH REAR LID LOCK UNIT - REAR LID, ADJUSTING.