Drive Axle Threaded Connection, Loosening And Tightening

Special Tools And Workshop Equipment Required

Loosen The Threaded Connection Between The Drive Axle And Wheel Hub

-- With vehicle still standing on its wheels, loosen bolt a maximum of 90°, otherwise wheel bearing will be pre-damaged.

-- Lift the vehicle just enough so that the wheels are hanging free.

-- Apply the brakes (a second technician required).

-- Remove the bolt -arrow-.

Tighten The Threaded Connection Between The Drive Axle And Wheel Hub

-- Replace the bolt -arrow-.

NOTE:

Before installing, clean the threads in the CV joint with a tap.

Wheels must not yet touch the ground to tighten the drive axle, wheel bearing may otherwise be damaged.

-- Apply the brakes (a second technician required).

-- Tighten bolt to 200 Nm.

-- Lower the vehicle onto its wheels.

-- Tighten bolt an additional 180°.