Knock Sensor 2 -G66-, REMOVING AND INSTALLING: Removing

WARNING: This page is about a different car, the 2015 Audi S7, 2015 Audi RS 7, 2014 Audi S7, 2014 Audi RS 7, and 2013 Audi S7. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Noise Insulation -1-

Courtesy of AUDI OF AMERICA, LLC

-- Remove the right front wheel, refer to Wheels, Tires, Wheel Alignment .

-- Remove the drive axle cover -1- in the right wheel housing.

-- Remove the right engine mount, refer to RIGHT ENGINE MOUNT, REMOVING AND INSTALLING .

-- Remove the nut -2- and free up the ground wire.

-- Remove the bolts -arrows- and remove the right engine support -1-.

Fig 2: Identifying Bolts & Right Engine Support

Courtesy of AUDI OF AMERICA, LLC

-- Disconnect the connector -4- from the starter by sliding the retainer back and pressing the release down.

-- Remove the nut -3- and the battery positive wire from the solenoid switch.

Fig 3: Identifying Connector And Nut

Courtesy of AUDI OF AMERICA, LLC

-- Disconnect the connector -1-.

-- Remove the bolt -2- and then the Knock Sensor 2 -G66-.

Fig 4: Identifying Bolt

Courtesy of AUDI OF AMERICA, LLC