Engine Speed Sensor -G28-, REMOVING AND INSTALLING: Removing

WARNING: This page is about a different car, the 2015 Audi S7, 2015 Audi RS 7, 2014 Audi S7, 2014 Audi RS 7, and 2013 Audi S7. However, it is still accessible from the selected car via links, so may be relevant.

-- Remove the rear noise insulation, refer to Noise Insulation .

Vehicles with DSG Transmission 0B5:

Fig 1: Removing Bolt

Courtesy of AUDI OF AMERICA, LLC

-- Remove the bolt -arrow- from the right coolant pipe on the transmission.

-- Remove bolts -arrows- and move the ATF cooler slightly to the side.

Fig 2: Identifying Bolts And ATF Cooler

Courtesy of AUDI OF AMERICA, LLC

NOTE:

Ignore item -1-.

Continuation for All Vehicles:

-- Disconnect the connector -2-.

-- Remove the bolt -1- and the Engine Speed Sensor -G28-.

Fig 3: Location Of Engine Speed (RPM) Sensor -G28-

Courtesy of AUDI OF AMERICA, LLC