LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2017 >> A7 Quattro Competition >> Repair and Diagnosis >> External Pages >> Different car >> Section 99 (4.0L - Ignition/Glow Plug System - Engine Code(S): CEUC & CRDB) >> 28 Ignition/Glow Plug System >> Ignition System >> Camshaft Position Sensor, Removing And Installing >> Camshaft Position Sensors -G163 - / - G301-, Removing And Installing >> Installing

Camshaft Position Sensors -G163 - / - G301-, Removing And Installing: Installing

WARNING: This page is about a different car, the 2015 Audi S7, 2015 Audi RS 7, 2014 Audi S7, 2014 Audi RS 7, and 2013 Audi S7. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal. Note the following:

NOTE:

If the Camshaft Position Sensor 3 -G300- was uninstalled, the coolant level must be checked, refer to COOLANT, DRAINING AND FILLING => .

WARNING:

Fire hazards and risk of damage for a faulty engine cover.

  • The engine cover must be always be installed before the hood is closed.
  • The engine may neither be started nor driven without an engine cover.
scientia non olet · About LEMON Manuals