Overview - Balance Shaft And Oil Pump Drive Chain
WARNING: This page is about a different car, the 2015 Audi A7 Quattro, 2014 Audi A7 Quattro, 2013 Audi A7, and 2012 Audi A7. However, it is still accessible from the selected car via links, so may be relevant.
- Crankshaft
- Drive Chain
- For power take-off
- Mark the running direction with paint for reinstallation
- Removing and installing, refer to DRIVE CHAIN BALANCE SHAFT, REMOVING AND INSTALLING .
- Drive Chain Sprocket
- For the oil pump
- Installed position: the side with lettering on it faces the engine
- Bolt
- 30 Nm +90°
- Replacing
- Pressure Spring
- Bolt
- 15 Nm +90°
- Replacing
- Balance Shaft Chain Sprocket
- Installed position: the side with lettering on it faces the transmission
- Chain Tensioner
- With glide track
- Bolt
- 10 Nm +45°
- Replacing