LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2017 >> A7 Quattro Competition >> Repair and Diagnosis >> External Pages >> Different car >> Section 96 (3.0L - Ignition System - Engine Code(S): CGXB & CTUA) >> Ignition System >> Ignition System >> Camshaft Position Sensor, Removing And Installing >> Installing

Camshaft Position Sensor, Removing And Installing: Installing

WARNING: This page is about a different car, the 2015 Audi A7 Quattro, 2014 Audi A7 Quattro, 2013 Audi A7, and 2012 Audi A7. However, it is still accessible from the selected car via links, so may be relevant.

-- Replace the O-ring and coat with clean engine oil.

-- Push in the camshaft position sensor carefully by hand.

-- Tighten the camshaft position sensor and connect the electrical connector.

-- Install in reverse order of removal.

scientia non olet · About LEMON Manuals