Overview - Cover And Cushion (Backrest With Pass-Through)

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2015 Audi S7, 2015 Audi RS 7, 2015 Audi A7 Quattro, 2014 Audi S7, and 2014 Audi RS 7. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Overview Of Cover And Cushion (Backrest With Pass-Through)

Courtesy of AUDI OF AMERICA, LLC

Lower Center Cushion
- Removing and installing. Refer to CENTER CUSHION, REMOVING AND INSTALLING, BACKREST WITH PASS-THROUGH .
- Engage the cushion to the pass-through door and press on it until it clicks into place
Backrest Cover
- Backrest cover and cushion, removing and installing. Refer to COVER AND CUSHION, REMOVING AND INSTALLING, REAR SEAT BACKREST .
- Backrest cover and cushion, separating and assembling. Refer to COVER AND CUSHION, SEPARATING, REAR SEAT BACKREST .
- Allocation.
- Make sure there are no folds after installing
Cushion Clip
- For attachment of backrest cover to backrest cushion
- Replace
- Install at the same location with Upholstery Clip PliersVAG1634.
Wire
- Embedded in the foam of the backrest cushion
- For attachment of backrest cover to backrest cushion
Contour Wire
- Pushed into the pocket of the backrest cover
- For attachment of backrest cover to backrest cushion
Backrest Frame
- Removing and installing. Refer to COVER AND CUSHION, REMOVING AND INSTALLING, REAR SEAT BACKREST .
Upper Center Cushion
- Removing and installing. Refer to COVER AND CUSHION, REMOVING AND INSTALLING, REAR SEAT BACKREST .
Backrest Cushion
- Backrest cover and cushion, removing and installing. Refer to COVER AND CUSHION, REMOVING AND INSTALLING, REAR SEAT BACKREST .
- Backrest cover and cushion, separating and assembling. Refer to COVER AND CUSHION, SEPARATING, REAR SEAT BACKREST .
- Allocation.
Clamping Strip
- Sewn into backrest cover
- For attaching the backrest cover on the backrest frame