Cover And Cushion, Separating, Rear Bench Seat: Removing

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2015 Audi S7, 2015 Audi RS 7, 2015 Audi A7 Quattro, 2014 Audi S7, and 2014 Audi RS 7. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Removing Seat Cover From Opening For Seat Belt Latch -Arrow-

Courtesy of AUDI OF AMERICA, LLC

-- Remove the rear bench seat. Refer to REAR BENCH SEAT, REMOVING AND INSTALLING .

-- Cut the upholstery clips (refer to COVER AND CUSHION, REMOVING AND INSTALLING, REAR BENCH SEAT ) all the way around the seat frame with piers.

-- Remove the seat cover and seat cushion from the seat frame.

-- Versions with heated seats: Free up the seat heating electrical connector.

-- Pull off the seat cover -1- from the seat cushion -3- as far as possible and cut the upholstery clips -2- using pliers.

-- Remove the seat cover from the opening for the seat belt latch -arrow-.

NOTE:

The version with a center storage compartment is shown in the illustration.