LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2017 >> A7 Quattro Competition >> Repair and Diagnosis >> External Pages >> Different car >> Section 95 (Seat Upholstery & Covers) >> 74 Seat Upholstery, Covers >> Front Seat Covers And Cushions >> Seat Pan Cover And Cushion, Removing And Installing >> Seat Pan Seat Bolster Cushion, Removing And Installing, MULTICONTOUR Seat >> Removing

Seat Pan Seat Bolster Cushion, Removing And Installing, MULTICONTOUR Seat: Removing

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2015 Audi S7, 2015 Audi RS 7, 2015 Audi A7 Quattro, 2014 Audi S7, and 2014 Audi RS 7. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
  • Follow all Safety Precautions when working with pyrotechnic components. Refer to PYROTECHNIC COMPONENTS SAFETY PRECAUTIONS .
  • Before handling pyrotechnic components (for example, disconnecting the connector), the person handling it must "discharge static electricity". This can be done by touching the door striker, for example.

-- Remove the front seat. Refer to FRONT SEAT, REMOVING AND INSTALLING .

-- Fasten the front seat on the Engine/Transmission Holder - Seat Repair FixtureVAS6136. Refer to FRONT SEAT, MOUNTING ON FIXTURE FOR SEAT REPAIR .

-- Remove the backrest. Refer to FRONT BACKREST, REMOVING AND INSTALLING, MULTICONTOUR SEAT .

-- Detach the molding -5- at the rear of the seat pan using the Backrest Panel Tool =3370.

Fig 1: Identifying Tab Hooks
GWWA74-10157Courtesy of AUDI OF AMERICA, LLC
NOTE:

Ignore -items 1 to 4-.

-- Detach the molding -3- from the seat frame on the sill-side.

Fig 2: Detaching Molding -1- And -2- From Seat Frame On Sill-Side
GWWA74-10406Courtesy of AUDI OF AMERICA, LLC

-- Detach the molding -1- and -2- from the seat frame on the sill-side.

-- Lift the seat cover -3- on the tunnel side.

Fig 3: Lifting Seat Cover -3- On Tunnel Side
GWWA74-10407Courtesy of AUDI OF AMERICA, LLC

-- Disengage the tab -1- on the seat frame on the tunnel side.

-- Detach the molding -2- from the seat pan frame on the tunnel side.

-- Disconnect the connector -1- and free up the heating element wire.

Fig 4: Identifying Seat Bolster, Heater And Connector
GWWA74-10167Courtesy of AUDI OF AMERICA, LLC

-- Remove the seat bolster cushion -3 and 4-.

NOTE:

The seat bolster cushion -3 and 4 - is only available together with the heating element -2 and 5.-

scientia non olet · About LEMON Manuals