Headrest Cover And Cushion, Removing And Installing: Installing
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2015 Audi S7, 2015 Audi RS 7, 2015 Audi A7 Quattro, 2014 Audi S7, and 2014 Audi RS 7. However, it is still accessible from the selected car via links, so may be relevant.
-- Insert cushion -1- with proper fit in cover -2-.
-- Insert headrest support in the cushion with cover.
-- Close the main zipper by moving the upper cover flat channel -1- over the cover -2-.
-- Push the edge of the material with the flat channel into the U-channel -5-.
-- Closing the side locks is similar to the closing the main lock.
-- After closing the main zipper and the side zippers with a needle or other pointed object, line up the cover and the profiles.
-- Make sure the cover lies on the cushion -3- without any wrinkles and without seam markings.
Installation is performed in reverse order of removal, while noting the following: