Driver/Front Passenger Seat Heating Element -Z6- / -Z8-, Removing And Installing, With Seat Ventilation: Removing

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2015 Audi S7, 2015 Audi RS 7, 2015 Audi A7 Quattro, 2014 Audi S7, and 2014 Audi RS 7. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Cutting Connecting Pieces -Arrows- And Remove Heating Elements

Courtesy of AUDI OF AMERICA, LLC

-- Separate the seat cover from the seat cushion. Refer to SEAT PAN COVER AND CUSHION, SEPARATING, STANDARD SEAT .

-- Vehicles with a front passenger seat occupant sensor: Loosen the seat occupied sensor -3- carefully from the heating element -1-.

-- Loosen the heating elements -A-, -B- and -C- carefully from the adhesive.

-- Cut the connecting pieces -arrows- and remove the heating elements.

NOTE:

The old heating elements -D- remain on the cushion -2- and will be covered over by the new heating element.