Vehicle Diagnostic Tester, CONNECTING AND SELECTING FUNCTIONS
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2015 Audi S7, 2015 Audi RS 7, 2015 Audi A7 Quattro, 2014 Audi S7, and 2014 Audi RS 7. However, it is still accessible from the selected car via links, so may be relevant.
-- Connect the Vehicle Diagnostic Tester to the vehicle data link connector with the ignition switched off.
NOTE:
Switch the ignition on.
DTC memory interrogated, errors shown corrected and DTC memory erased.
The tester is ready for use when the vehicle symbol is displayed.
-- Turn on the ignition.
-- Start the program in Guided Functions.
-- Select in succession:
- Brand
- Type
- Model year
- Version
- Engine Code
-- Confirm data entered.
Wait until the tester has checked all control modules in vehicle.
-- Press the Go to button and select "Function/component selection".
-- Select "Suspension"
-- Select "Brake system"
-- Select the program on the display.