Brake Lamp Switch -F-, REMOVING AND INSTALLING: Removing

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2015 Audi S7, 2015 Audi RS 7, 2015 Audi A7 Quattro, 2014 Audi S7, and 2014 Audi RS 7. However, it is still accessible from the selected car via links, so may be relevant.

-- Move the seat all the way back as far as it will go.

-- Turn off the ignition.

-- Remove the storage compartment under the instrument panel on the driver side. Refer to Interior Trim .

-- Remove the footwell vent.

-- Disconnect the connector to the Brake Lamp Switch -F -.

-- Push the plunger on the Brake Lamp Switch -F- -B- all the way in.

Fig 1: Component Location Brake Lamp Switch -F-

Courtesy of AUDI OF AMERICA, LLC

-- Turn the colored piece on the Brake Lamp Switch -F-, with the plunger still pushed in, all the way to the left -arrow A- to release the sensor.

NOTE: The plunger must remain pushed in while releasing the Brake Lamp Switch -F-.

-- Release the Brake Lamp Switch -F- plunger after the switch has been released.

-- Insert the Release Tool for Brake Light Switch T40168A between the plunger on the Brake Lamp Switch -F- and the brake pedal.

The cone on the tool must face in the direction of the driver seat. The opening on the tool must align with the projection on the Brake Lamp Switch -F-.

-- Press the Release Tool for Brake Light Switch T40168A against the Brake Lamp Switch -F -. The three tabs on the Brake Lamp Switch -F- unlock at the same time.

-- Remove the Brake Lamp Switch -F- from the mount -C-.

Fig 2: Component Location Brake Lamp Switch -F-

Courtesy of AUDI OF AMERICA, LLC