Front Abs Wheel Speed Sensors -G45- / -G47-, Removing And Installing: Installing
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2015 Audi S7, 2015 Audi RS 7, 2015 Audi A7 Quattro, 2014 Audi S7, and 2014 Audi RS 7. However, it is still accessible from the selected car via links, so may be relevant.
Install in reverse order of removal while noting the following:
-- Before inserting the speed sensor, clean the hole inner surface and coat the speed sensor all-round with lubricant G 000 650.
-- Install the speed sensor.
-- Tighten the bolt to 9 Nm.
-- Connect the connector to the speed sensor -1-.
-- Turn the steering completely left and right after installation, making sure the speed sensor wiring has sufficient clearance.
-- Lower vehicle.