Zero Position, Slotted Guide Rail Guide, Checking And Adjusting
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2015 Audi S7, 2015 Audi RS 7, 2015 Audi A7 Quattro, 2014 Audi S7, and 2014 Audi RS 7. However, it is still accessible from the selected car via links, so may be relevant.
Checking
Zero position can only be checked when sunroof panel is installed.
-- Boot removed.
-- Drive back sunroof panel and close again.
-- On vehicles with glass panel, slide sliding headliner completely toward rear.
-- Close sunroof.
-- For a correct zero position, guide pins -1- in center on tilting mechanism must align with marking -arrow- on link guide -2-.
Adjusting
-- Sunroof motor removed.
-- Sunroof panel removed
-- Push the slotted guide rail on both sides by hand into the zero position.
-- Adjust and install the motor in the zero position.