Fastener Tightening Specifications
WARNING: This page is about a different car, the 2015 Audi S7, 2014 Audi S7, and 2013 Audi S7. However, it is still accessible from the selected car via links, so may be relevant.
| Components | Fastener Size | Nm |
|---|---|---|
| ATF Filter Cover to ATF Filter Housing | - | 8 |
| ATF Filter Housing to Transmission Housing | - | 10 |
| ATF Pipe Connection to Transmission Housing | - | 10 |
| Cable Guide for the RPM Sensors to Transmission Housing | - | 8 |
| Connector Housing to Transmission Housing | - | 8 |
| Oil Pump to Transmission Housing | - | 25 |
| Retaining Plate to ATF Pressure Pipes | - | 10 |
| Sensor module to Transmission Intermediate Housing | - | 8 |
| Side Shaft to Transmission Intermediate Housing 1 | - | 150 + 90° |
| Suction Jet Pump to Transmission Housing | - | 4.5 |
|
||
ATF Oil Pan, Tightening Specification and Sequence
-- Tighten the bolts in two stages as described below.
-- Install the bolts -arrows- hand-tight.
-- Tighten the bolts -1 through 15- diagonally to 10 Nm and in steps.
Mechatronic, Tightening Specification and Sequence
-- Tighten the bolts to 10 Nm in the following sequence: -1 to 6-.
Circuit Board 1 - Tightening Specification and Sequence
-- Tighten the bolts to 3 Nm in the following sequence: -1 to 5-.
Circuit Board 2 - Tightening Specification and Sequence
-- Tighten the bolts to 3 Nm in the following sequence: -1 to 5-.
Transmission Intermediate Housing to Transmission Housing - Tightening Specification and Sequence
Fig 5: Transmission Intermediate Housing To Transmission Housing - Tightening Specification And Sequence
NOTE:
Replace the bolts.
-- Tighten bolts in 2 stages as follows:
| Step | Bolts | Tightening Specification/Additional Turn |
|---|---|---|
| 1. | -Arrows- | 8 Nm diagonally |
| 2. | -Arrows- | 120° additional turn, diagonally |