Transmission Guided Functions: Procedure

WARNING: This page is about a different car, the 2015 Audi S7, 2014 Audi S7, and 2013 Audi S7. However, it is still accessible from the selected car via links, so may be relevant.

Vehicle Diagnostic Tester is connected.

-- Perform "Guided Function" in Guided Functions , directory 02 - transmission electronics, functions on the Vehicle Diagnostic Tester.

Conditions:

Follow the instructions on the Vehicle Diagnostic Tester exactly so that "Guided Functions" can be performed successfully.

Perform "Guided Functions" with a Vehicle Diagnostic Tester after performing the following:

Replacing the selector mechanism function unit: 02 - basic setting (Repair Group 34) , refer to 1
Working on the selector lever cable, adjusting the selector lever cable: 02 - basic setting (Repair Group 34) , refer to 2
Replacing the S tronic Transmission Mechatronic -J743- and the Transmission Control Module -J217- : 02 - replace control module/Mechatronic (Repair Group 34) , refer to 3
Replacing the dual clutch, replacing the transmission control module -J217-, repairing the transmission, replacing the components in the transmission: 02- Basic Setting (Rep.-Gr. 34) , refer to 4

Replacing the shift mechanism function unit.

Fig 1: Disconnecting Selector Mechanism Electrical Connectors And Removing Bolts
Courtesy of AUDI OF AMERICA, LLC

NOTE: Shift Mechanism Function Unit, Removing and Installing, refer to SELECTOR MECHANISM, REMOVING AND INSTALLING .

The following steps must be performed after completing this procedure:

-- Under Guided Functions in the directory 02 - transmission electronics , select the basic setting (Repair Group 34) "Guided Function".

-- Select calibrate drive position sensor -G676 and then follow the instructions given on the Vehicle Diagnostic Tester.
Assembly work on the selector lever cable when adjusting the cable.

Fig 2: Insert T40031 Through Opening In Selector Mechanism
Courtesy of AUDI OF AMERICA, LLC

NOTE: Adjust the selector lever cable, refer to SELECTOR LEVER CABLE, CHECKING AND ADJUSTING .

The following steps must be performed after completing this procedure:

-- Under Guided Functions in the directory 02 - transmission electronics , select the basic setting (Repair Group 34) "Guided Function".

-- Select calibrate drive position sensor -G676 and then follow the instructions given on the Vehicle Diagnostic Tester.
Replacing the S tronic Transmission Mechatronic -J743- and Transmission Control Module -J217-

Fig 3: Identifying Mechatronic, Tightening Sequence
Courtesy of AUDI OF AMERICA, LLC

NOTE: Direct Transmission Mechatronic -J743-, Removing and Installing, refer to MECHATRONIC, REMOVING AND INSTALLING .

The following steps must be performed after completing this procedure:

-- Select Guided Functions in the directory 02 - transmission electronics and the replace control module/Mechatronic (Repair Group 34) "Guided Function" and then follow the instructions given on the Vehicle Diagnostic Tester.
Replacing the dual clutch.

Fig 4: Identifying Dual Clutch Components
Courtesy of AUDI OF AMERICA, LLC

NOTE: Dual clutch, removing and installing, refer to Clutch .

The following steps must be performed after completing this procedure:

-- Under Guided Functions in the directory 02 - transmission electronics , select the basic setting (Repair Group 34) "Guided Function".

-- Select the basic setting adapt clutch slip points and then follow the instructions given on the Vehicle Diagnostic Tester.