Overview - Final Drive
WARNING: This page is about a different car, the 2015 Audi S7, 2014 Audi S7, and 2013 Audi S7. However, it is still accessible from the selected car via links, so may be relevant.
- Flywheel
- Shaft Seal
- For the left flange shaft
- Between the final drive and the transmission housing
- Replacing, refer to Seals .
- Shim
- Behind the taper roller bearing outer race
- Taper Roller Bearing Outer Race
- Differential
- Bolt
- Quantity 10
- Tightening specification and sequence, refer to Final Drive, Differential .
- Locking Ring
- Replacing
- Right Flange Shaft
- Shaft Seal
- For the right flange shaft
- Replacing, refer to Seals .
- Front Final Drive Cover
- Removing and installing, refer to Seals .
- O-Ring
- On the front final drive cover
- Replacing
- Shim
- Behind the taper roller bearing outer race
- Taper Roller Bearing Outer Race
- Spring Pin
- Selector Lever
- Shaft Seal
- For the selector shaft
- Refer to SELECTOR SHAFT SEAL, REPLACING
- Bolt
- Quantity: 3
- Tightening specification, refer to Final Drive, Differential .
- Left Flange Shaft
- Removing and installing, refer to Differential .
- Gear Carrier
- Attached to the left flange shaft with the bearing -20- and the circlip -21-
- Bearings
- For the left flange shaft
- Pressed on to the left flange shaft
- Locking Ring
- For the left flange shaft bearing
- Replacing
- Shaft Seal
- For the input shaft
- Replacing, refer to Input Shaft .