Right Flange Shaft, Removing And Installing: Installing
WARNING: This page is about a different car, the 2015 Audi S7, 2015 Audi RS 7, 2014 Audi S7, 2014 Audi RS 7, and 2013 Audi S7. However, it is still accessible from the selected car via links, so may be relevant.
Install in reverse order of removal. Note the following:
NOTE:
Replace the circlip on the right flange shaft.
-- Clamp the flange shaft in a vise with jaw protectors. Remove the old circlip from the groove in the flange shaft using the new circlip -A-.
-- Fill the space between the sealing- and dust lip half way with sealing grease.
-- Drive in the right flange shaft using the Bearing/Bushing Installer - Multiple Use VW295.
-- Fill the transmission fluid (MTF).
- Audi A4, A5, Q5, refer to Transmission Fluid .
- Audi A6, A7, refer to Final Drive, Differential .