Wheel Bearing Unit, Fwd, Removing And Installing: Installing

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2015 Audi S7, 2015 Audi RS 7, 2015 Audi A7 Quattro, 2014 Audi S7, and 2014 Audi RS 7. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal. Note the following:

-- Clean the front seal.

Fig 1: Front Seal And Grease Stub Axle

Courtesy of AUDI OF AMERICA, LLC

-- Install the front seal and grease the stub axle -arrow- lightly with Grease.

-- Install the brake caliper and the brake rotor, refer to [[Editorial:Find destination]] .

-- Install the new cap with the Sleeve 3241/4 -1-.

Fig 2: Dust Cap

Courtesy of AUDI OF AMERICA, LLC

NOTE:

Always replace a damaged cap.

Damaged caps allow moisture to get in. Therefore, always use the tool shown.

-- Tighten the wheel bearing unit bolt.

-- Install rear wheel, refer to WHEELS AND TIRES .