Overview - Wheel Bearing, Vehicles With Fwd

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2015 Audi S7, 2015 Audi RS 7, 2015 Audi A7 Quattro, 2014 Audi S7, and 2014 Audi RS 7. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Wheel Bearing, Vehicles With FWD

Courtesy of AUDI OF AMERICA, LLC

Bolt
- 10 Nm
Cover Plate
- For the brake rotor
Bonded Rubber Bushing
- Replacing, refer to WHEEL BEARING HOUSING BONDED RUBBER BUSHING, REPLACING, AWD VEHICLES .
Wheel Bearing Housing
- Removing and installing, refer to WHEEL BEARING HOUSING, REMOVING AND INSTALLING, FWD VEHICLES .
Rear Speed Sensor
- Left Rear ABS Wheel Speed Sensor -G46-
- Right Rear ABS Wheel Speed Sensor -G44-
Bolt
- Tightening specification, refer to [[Editorial:Find destination]] .
Front Seal
Wheel Hub
CAUTION:
- Avoid contaminating with dirt and damaging the seal when setting down/storing, refer to Fig 2.
- Wheel bearing unit, removing and installing, refer to WHEEL BEARING UNIT, AWD, REMOVING AND INSTALLING .
- For servicing the wheel bearing unit, refer to WHEEL BEARING UNIT, SERVICING .
Brake Rotor
Bolt
- 200 Nm +180° turn
- Always replace if removed
- Follow the assembly information when loosening and tightening, refer to DRIVE AXLE THREADED CONNECTION, LOOSENING AND TIGHTENING .
Dust Cap
Bolt
- Tightening specification, refer to [[Editorial:Find destination]] .

Fig 2: Avoid Contaminating With Dirt And Damaging Seal When Setting Down/Storing

Courtesy of AUDI OF AMERICA, LLC

The wheel bearing -1- must always face up.
Always set the wheel bearing unit down on the wheel hub -2-.