Overview - Wheel Bearing Housing, Vehicles With AWD
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2015 Audi S7, 2015 Audi RS 7, 2015 Audi A7 Quattro, 2014 Audi S7, and 2014 Audi RS 7. However, it is still accessible from the selected car via links, so may be relevant.
- Bolt
- 10 Nm
- Cover Plate
- For the brake rotor
- Bonded Rubber Bushing
- Replacing, refer to WHEEL BEARING HOUSING BONDED RUBBER BUSHING, REPLACING, AWD VEHICLES .
- Wheel Bearing Housing
- Removing and installing, refer to WHEEL BEARING HOUSING, AWD, REMOVING AND INSTALLING .
- Bolt
- 80 Nm +90° turn
- Always replace if removed
- drive axle
- There are different versions .
- Rear Speed Sensor
- Left Rear ABS Wheel Speed Sensor -G46-
- Right Rear ABS Wheel Speed Sensor -G44-
- Bolt
- Tightening specification, refer to [[Editorial:Find destination]] .
- Wheel BearingCAUTION:
- Avoid contaminating with dirt and damaging the seal when lifting, setting down/storing, refer to Fig 2.
- Wheel bearing unit, removing and installing, refer to WHEEL BEARING UNIT, AWD, REMOVING AND INSTALLING .
- For servicing the wheel bearing unit, refer to WHEEL BEARING UNIT, SERVICING .
- Wheel HubCAUTION:
- Avoid contaminating with dirt and damaging the seal when lifting, setting down/storing, refer to Fig 2.
- Wheel bearing unit, removing and installing, refer to WHEEL BEARING UNIT, AWD, REMOVING AND INSTALLING .
- For servicing the wheel bearing unit, refer to WHEEL BEARING UNIT, SERVICING .
- Brake Rotor
- Bolt
- Tightening specification -item 14- 14.
- Bolt
- Tightening specification, refer to [[Editorial:Find destination]] .
- The wheel bearing -1- must always face up.
- Always set the wheel bearing down on the wheel hub -2-.
- Never reach into the inside when lifting the wheel bearing.
- Hold the wheel bearing only on the outside.
The same procedure also applies to the wheel bearing without a wheel hub.