Spring, Removing And Installing, Coil Spring: Notes
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2015 Audi S7, 2015 Audi RS 7, 2015 Audi A7 Quattro, 2014 Audi S7, and 2014 Audi RS 7. However, it is still accessible from the selected car via links, so may be relevant.
Special tools and workshop equipment required
- Pneumatic/Hydraulic Foot Pump VAS6179
- Spring Tensioning System VAS6274
- Spring Tensioning System - Audi Set VAS6274/10
WARNING:
- Before removing and installing the coil spring the Spring Tensioning System VAS6274 with the Spring Tensioning System - Audi Set VAS6274/10 must be retrofitted.
- Retrofit the Spring Tensioning System VAS6274 with the Spring Tensioning System - Audi Set VAS6274/10, refer to SPRING TENSIONING SYSTEM, CONVERTING .
NOTE:
The rest of the tools from the Spring Tensioning System - Audi Set VAS6274/10 are needed later in the procedure.
- Spring Tensioning System - Audi Set - Thrust Plate with Swivel Bearing VAS6274/10-1
- Spring Tensioning System - Audi Set - Thrust Plate with Securing Plate VAS6274/10-2
- Locking device Bolts
- Spring Tensioning System - Audi Set - Spindle VAS6274/10-4
- Sleeve