Stabilizer Bar, Removing And Installing: Removing
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2015 Audi S7, 2015 Audi RS 7, 2015 Audi A7 Quattro, 2014 Audi S7, and 2014 Audi RS 7. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
- Do not damage the paint on the stabilizer bar when removing and installing.
-- Remove the bolt -1-.
NOTE:
The threaded connection between the coupling rod and the lower transverse link is under tension.
Press the lower transverse link gently downward when removing the bolt -1-.
-- Remove the nut -3-, the bolt -2- and the coupling rod -4-.
-- Remove the rear section from the exhaust system, refer to [For engine(s) CPNB] Exhaust System, Emission Controls .
-- Remove the left and right bolts -1-. Then remove the stabilizer bar -2- to the left.
NOTE:
The stabilizer bar -2- is removed and installed completely with the rubber bushings and clamps. Do not remove the clamps and rubber bushings.