Overview - Stabilizer Bar
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2015 Audi S7, 2015 Audi RS 7, 2015 Audi A7 Quattro, 2014 Audi S7, and 2014 Audi RS 7. However, it is still accessible from the selected car via links, so may be relevant.
- Bolt
- 40 Nm +90° turn
- Always replace if removed
- Must be tightened in the curb weight position, refer to WHEEL BEARING IN CURB WEIGHT, LIFTING VEHICLES WITH COIL SPRING .
- Coupling rod
- Removing and installing, refer to STABILIZER BAR, REMOVING AND INSTALLING .
- Bolt
- 40 Nm +90° turn
- Always replace if removed
- Must be tightened in the curb weight position, refer to WHEEL BEARING IN CURB WEIGHT, LIFTING VEHICLES WITH COIL SPRING .
- Nut
- Always replace if removed
- Lower Transverse Link
- Subframe
- Stabilizer Bar
- Removing and installing, refer to STABILIZER BAR, REMOVING AND INSTALLING .
- The rubber bushing and clamp must not be separated from the stabilizer bar.
- Bolt
- 25 Nm +90° turn
- Always replace if removed
- Tighten evenly